Front Bearing For Gearbox Output Shaft. Remove Seals if Required. Size 75-32-20. Shown As Number 16 In Diagram. Fits DFM / DFSK Models With a 1300cc Engine
Gearshift Cable Set. Consisting of Both Upper and Side Cables. Shown As Numbers 3 And 4 In Diagram. Fits DFM / DFSK Loadhopper Models With A 1300cc Engine.
IMPORTANT: WHEN REPLACING GEARSHIFT CABLES EXAMINE GEARLEVER BRACKET ASSEMBLY. BRACKETS CAN FRACTURE IN THE AREA OF WHERE CABLES MOUNT AND CAUSE GEAR SELECTION PROBLEMS!
Gearshift Cable Set. Consisting of Both Upper and Side Cables. Shown As Numbers 3 And 4 In Diagram. Fits DFSK Loadhopper K01H Models With A 1200cc Engine.
Gearshift Cable Set. Consisting of Both Upper and Side Cables. Shown As Numbers 3 And 4 In Diagram. Fits DFM / DFSK Models With A 1000cc AF10 Engine.
IMPORTANT: WHEN REPLACING GEARSHIFT CABLES EXAMINE GEARLEVER BRACKET ASSEMBLY. BRACKETS CAN FRACTURE IN THE AREA OF WHERE CABLES MOUNT AND CAUSE GEAR SELECTION PROBLEMS!
Gearshift Cable Set. Consisting of Both Upper and Side Cables. Shown As Numbers 3 And 4 In Diagram. Fits DFSK C31/C32 Models with A 1500cc Engine.
IMPORTANT: WHEN REPLACING GEARSHIFT CABLES EXAMINE GEARLEVER BRACKET ASSEMBLY. BRACKETS CAN FRACTURE IN THE AREA OF WERE CABLES MOUNT AND CAUSE GEAR SELECTION PROBLEMS!
Gearshift Lever Assembly. Shown As Number 2 In Diagram. (Supplied Without Rubber Boot And Knob).Fits DFM / DFSK Models Pre 2015 With A 1300cc Engine.
Not Big Cabin Pickup
Repair Kit Consisting Of New Input Shaft, Inner Needle Bearing, Front Bearing And Seal. Shown As Numbers 2 4 5 6 In The Diagram. Fits DFM / DFSK Loadhopper Models With a 1000cc Engine
Brake-Clutch Pedal Box Assembly. Shown As Numbers 14-25 (3) In Diagram. Comes With Pedal Rubbers And Brake Light Switch. Fits DFM / DFSK Models With 1000cc/1200cc/ 1300cc Engines.
Speedometer Gearbox Speed Sensor. Shown As Item 2 In Diagram.Fits DFM / DFSK Loadhopper Models With A 1000cc Engine And 4x4 With 1300cc Engine. Secures to Gearbox With Pinch Bolt.
Bearing And Seal Kit To Overhaul Rear Axle Differential. Shown As Items 3,9,12,13,14 In Diagram. Fits DFM / DFSK Models With 1000cc /1200cc /1300cc Engines
IMPORTANT
THERE ARE TWO TYPES OF OUTER DIFF CARRIER BEARINGS BOTH TYPES ARE INCLUDED WITHIN THE KIT..USE AS APPROPRIATE
Differential Unit For Rear Axle. Ready To Fit. Fits DFM / DFSK Loadhopper Models With A 1300cc Engine.
IMPORTANT:- DO NOT UNDER ANY CIRCUMSTANCES MOVE PINION NUTS TAGGED POSITION.
Differential Unit For Rear Axle. Fits DFSK "C" Series Models With 1500cc Engine And 43:9 Diff Ratio. THIS DIFF IS BOLTED TO FRONT OF AXLE CASING.
IMPORTANT:- DO NOT UNDER ANY CIRCUMSTANCES MOVE PINION NUTS TAGGED POSITION.
Rear Axle Half Shaft. Shown As Number 14 In Diagram. Wheel Studs Not Fitted. WHEEL BEARING KIT OEM1001397/T WILL ALSO BE REQUIRED WHEN FITTING THIS PART. Fits DFM / DFSK Loadhopper Models With 1000cc/1200cc/1300cc Engines. FOR ABS BRAKES NEW ABS RING WILL BE REQUIRED PART NUMBER (TO BE ADVISED)